 |
上海維特銳實業發展有限公司
主營產品： 威仕流量計,VSE流量計,賀德克傳感器,阿托斯比例閥 |
員.png)
11
聯系電話
|
上海維特銳實業發展有限公司
主營產品： 威仕流量計,VSE流量計,賀德克傳感器,阿托斯比例閥 |
聯系電話
2017-2-10 閱讀(1167)
| 提 供 商 | 上海維特銳實業發展有限公司 | 資料大小 | 255.4KB |
|---|---|---|---|
| 資料圖片 | 【點擊查看】 | 下載次數 | 44次 |
| 資料類型 | PDF 文件 | 瀏覽次數 | 1167次 |
The G123-825 Buffer Amplifier is intended to interface between the output of
standard signal sources, such as a PLC or servo amplifier, and a Moog servo\
proportional valve. It accepts three types of signal input and can output most
of the Moog servo\proportional valve signals. It has a single pole active filter
to remove noise from the input signal.
PLC ±10 V and 4-20 mA inputs:
The G123-825 interfaces between standard PLC analog output signals of ±10 V
and 4-20 mA on the input side and the Moog valve on the output side. This solves
the compatibility problem between these signals and the valve requirement.
Mechanical feedback (mfb) valve input:
The G123-825 interfaces between the current output of a servo amplifier, on one
side, and a Moog valve on the other. This enables old mfb valves to be replaced by
modern electrical feedback (efb) valves, without changing the servo amplifier.
The buffer amplifier takes the existing servo amplifier output and converts it
to an efb compatible signal.
Input filter:
The G123-825 has a filter to remove noise from the input signal. The filter time
constant is switch selectable. The switch selections sum, so a large variety of time
constants is available.
Outputs:
The output signals are switch selectable. They are:
4 to 20 mA fixed. Suitable for efb valves •
0 to ±10 V fixed. Suitable for efb valves •
0 to ±5 to ±100 mA switch selectable. Suitable for mfb valves. •
Suitable for efb valves when set to ±10 mA
The output current selector switches can have more than one selected,
so the selected values sum. For example, selecting 30 and 50 mA together
gives a full scale output of ±80 mA.
The buffer amplifier is housed in a compact DIN rail housing and requires
a 24 VDC supply. Front panel test points and valve drive LEDs facilitate
commissioning and trouble shooting
Signal input ：4 to 20 mA
0 to ±100 mA
0 to ±10 V
Current signal input Terminals 4 to 8. 50 Ohm
Voltage signal input Terminal 3. 100 k Ohm or 1 k Ohm
with low Rin selected.
Valve drive outputs 0 to ±10 V @ 1 k Ohm min load
4 to 20 mA @ 500 Ohm max load
更多穆格產品咨詢請點擊此處
